High Jump Pit.
Made of solid foam filler with vinyl coated nylon top. Bottom consists of mesh breather sides and handles for carrying.

Size 5' x 10' 12" thickness

General Instructions for Crash Mats, Jump Pits & Pole Vault Pits:
The foam in the jump pit has been vacuum packed to reduce your freight cost. The foam returns to 95% of its original size only as it has been cut oversize and, therefore, can only be installed in the envelope after the vacuum is broken.

Install as follows:
1.) Remove foam from the packaging immediately upon arrival
2.) Activate silicone coating by wetting the inside of the envelope with a damp sponge or cloth
3.) Fold envelope back as far as the zipper permits
4.) Slide in foam and zip close the envelope

Care of Mat:
1.) Do not use the mat if foam is wet
2.) Avoid direct sunlight as much as possible
3.) Be sure the breather is not obstructed when using the mat
4.) Do not drag the mat , instead carry to avoid snagging

WARNING
DO NOT USE CRASH MAT 12" THICK OR LESS DIRECTLY ON FLOOR WITHOUT A MAT UNDERNEATH.
Note that these are general instructions. Instructions for individual product may vary.

SHIPPING COST FOR THIS PRODUCT IS ONLY ESTIMATED. DUE TO THE NATURE OF THE PRODUCT, ACTUAL SHIPPING CHARGES WILL BE DETERMINED AT THE TIME OF SHIPPING AND YOU WILL BE NOTIFIED IF THERE IS ANY CHANGE TO THE ORIGINAL SHIPPING COST.